Honeywell TC-FCCN01 Redundant Net Interface Module The Honeywell Redundant Net Interface Module, also cataloged as the Redundant Net Interface Module...
Read more
Available on working days between 9:00 am to 6:00 pm
Email us: sales2@industriaxplc.com
Available 24/7 for inquiries and support
Description
Honeywell TC-FCCN01 Redundant Net Interface Module
The Honeywell Redundant Net Interface Module, also cataloged as the Redundant Net Interface Module Network Interface Module, operates as a dedicated hardware component for redundant network data exchange and interface arbitration within industrial control network topologies. Electrical signaling and communication routing are executed through deterministic backplane and fieldbus-linked network channels with redundancy coordination logic.
Suffix Breakdown & Model Matrix
No structured suffix segmentation is defined for this module based on the provided identification data. The designation is treated as a single functional unit: Redundant Net Interface Module.
Hardware Specifications
Parameter
Specification
Model
Redundant Net Interface Module
Brand
Honeywell
Origin
United States
Weight
0.3 kg
Dimensions
1.5 in x 6.6 in x 5.2 in (3.8 cm x 16.8 cm x 13.2 cm)
Operating Temp
Not specified
Power Consumption
Not specified
Interface Type
Redundant industrial network interface
Communication Media
Network backplane / field network coupling
Honeywell DCS Network Interface Behavior (Process Control Integration)
Within Honeywell distributed control architectures, redundant interface modules participate in channel-to-channel synchronization across control network segments. Communication behavior is aligned with process control data transport mechanisms such as 4-20 mA loop integration layers and fieldbus gateway bridging structures where applicable.
Redundant paths are typically evaluated at the network arbitration layer, ensuring deterministic switchover logic under link degradation conditions. Channel isolation behavior is implemented at the hardware coupling level to reduce cross-channel interference during simultaneous network activity.
Frequently Asked Questions (FAQ)
Q: Does the module support hot-swapping in redundant network configurations? A: Hot-swap capability depends on the host backplane implementation. In redundant configurations, interface state synchronization must complete prior to physical insertion or removal to avoid bus arbitration conflicts.
Q: How is redundancy switching latency determined in network failure conditions? A: Switching behavior is governed by controller-level redundancy logic and backplane scan cycle timing. Latency is typically bounded by system scan synchronization rather than the module itself.
Q: Can the module isolate communication faults between redundant channels? A: Electrical channel isolation is implemented at the interface coupling stage, preventing fault propagation between redundant network paths under standard operating conditions.
Field Installation Guidelines
The module shall be installed on a grounded industrial backplane compliant with system-specific mechanical keying requirements. Ensure that network cabling to adjacent interface devices maintains controlled impedance routing and avoids proximity to high-energy switching conductors.
Shield termination should be executed at a single-point grounding reference to prevent ground loop formation across redundant network segments. Connector seating force must be applied uniformly to avoid partial backplane engagement, which may result in intermittent signal arbitration faults.
M12 network tee components such as RS485/CANopen distribution adapters should be installed with controlled torque on threaded coupling interfaces to maintain stable differential signaling integrity.
