Honeywell 80364102-100 Network Interface Module PCB Assembly The Honeywell 80364102-100, also cataloged as the 51304511-100 Network Interface Module PCB Assembly,...
Read more
The Honeywell 80364102-100, also cataloged as the 51304511-100 Network Interface Module PCB Assembly, operates as a dedicated hardware component for LCN communication signal processing within Honeywell TDC 3000 and Experion PKS platforms.
Hardware Specifications
Parameter
Specification
Model
Honeywell 80364102-100
Brand
Honeywell / Yamatake Honeywell
Origin
United States
Component Type
Network Interface Module (NIM) Modem / Communication PCB
Assembly Part Number
51304511-100
System Compatibility
Honeywell TDC 3000 and Experion PKS DCS platforms
Function
LCN network communication, modem signal processing, communication bus interface
Form Factor
Honeywell chassis plug-in PCB assembly
Mounting
Direct rack or chassis slot installation
Operating Temp
0 deg C to +60 deg C standard operating range
Relative Humidity
5% to 95% non-condensing
Power Consumption
Not specified; supplied through Honeywell system chassis backplane
DCS Network Communication Interface Characteristics
The Honeywell 80364102-100 performs network interface functions inside Honeywell distributed control architectures. The PCB processes communication signals between Local Control Network (LCN) nodes and internal system communication paths.
The module operates as a modem communication assembly and manages signal modulation, demodulation, and network data exchange. Therefore, the board requires correct chassis placement and compatible firmware configuration to maintain communication with the host control system.
For Honeywell process control applications, the communication architecture commonly integrates field device protocols such as 4-20 mA HART loop communication and FOUNDATION Fieldbus or Profibus PA connectivity through dedicated I/O modules. However, the 80364102-100 itself functions primarily as an LCN network interface assembly rather than a field signal acquisition module.
The board design supports channel communication integrity through controlled signal routing and noise reduction methods. In addition, technicians should verify grounding and shielding practices when installing the module in industrial control cabinets.
Frequently Asked Questions
Q: Is the Honeywell 80364102-100 a field signal input or output module? A: No. The 80364102-100 is a Network Interface Module PCB assembly. It performs communication processing functions and does not directly terminate field analog or digital signals.
Q: Can the 80364102-100 be installed while the system remains powered? A: The module supports Honeywell chassis-based replacement procedures. However, hot-swap operation depends on the specific TDC 3000 or Experion PKS hardware configuration and maintenance guidelines.
Q: Does the module require external communication wiring? A: The PCB connects through the Honeywell chassis and internal communication interfaces. External wiring requirements depend on the installed rack and network configuration.
Field Installation Guidelines
Install the PCB assembly only in the designated Honeywell chassis slot specified by the system configuration.
Verify rack addressing, module identification, and controller communication status before replacement.
Use appropriate ESD protection when handling the PCB assembly.
Confirm that cabinet grounding and cable shielding methods follow Honeywell installation practices.
Separate communication wiring from high-current power conductors to reduce electrical interference.
After installation, check diagnostic indicators and verify network communication status through the DCS engineering interface.
