Description

GE IS210MACCH2AGG Mark VIe Network Interface Card

Configured for high-speed industrial network communication in the GE Mark VIe Speedtronic control system, the GE IS210MACCH2AGG (IS210MACCH2AGG Network Interface Card) provides PCIe-based Ethernet data transfer and physical communication execution between turbine control modules and external control networks.

Hardware Specifications

Parameter	Specification
Model	IS210MACCH2AGG
Brand	GE Fanuc / General Electric
Series	Mark VIe Speedtronic Control System
Product Type	Network Interface Card
Origin	United States
Interface	PCIe 3.0 x16
Network Speed	10 Gigabit Ethernet (10GbE)
Connector Type	SFP+
Supported Protocols	TCP/IP, UDP, IPsec
Data Transfer Rate	Up to 10 Gbps full-duplex
Buffer Size	256 KB
Power Supply	5 VDC, approximately 425 mA
Weight	0.4 kg
Dimensions	15.2 x 10.2 x 2.5 cm
Operating Temp	0 deg C to 60 deg C standard variant; -40 deg C to +85 deg C industrial variant
Storage Temp	-40 deg C to +85 deg C
Humidity Range	10% to 90% non-condensing
Power Consumption	Approximately 2.1 W

Industrial Ethernet Communication Architecture

The IS210MACCH2AGG implements high-speed Ethernet connectivity within Mark VIe turbine control architectures through a PCIe 3.0 x16 interface. The module supports TCP/IP, UDP, and IPsec protocol processing for data exchange between controller nodes, SCADA systems, DCS interfaces, and plant-level Ethernet networks.

Network functions include VLAN tagging, jumbo frame handling, and flow control mechanisms to maintain deterministic packet transmission behavior under industrial communication loads. The SFP+ connector interface allows integration with compatible optical or copper transceiver configurations.

Frequently Asked Questions

Q: What communication interface is provided by the IS210MACCH2AGG?

A: The module provides a PCIe 3.0 x16 host interface with a 10 Gigabit Ethernet network interface using an SFP+ connector.

Q: Which communication protocols are supported by this network interface card?

A: The module supports TCP/IP, UDP, and IPsec protocol operation for industrial Ethernet data communication.

Q: What are the installation considerations for the module in a Mark VIe system?

A: Installation requires compatible PCIe slot allocation, proper transceiver selection, and compliance with the host controller chassis grounding and cable routing requirements.

Field Installation Guidelines

Install the IS210MACCH2AGG in a compatible Mark VIe controller chassis with the system power removed before hardware insertion or removal. Verify PCIe slot compatibility and ensure the module is fully seated before applying power.

Use approved SFP+ transceivers and route Ethernet cables separately from high-voltage power conductors to reduce electromagnetic interference. Maintain proper shield termination practices where shielded Ethernet cabling is used. Ground the chassis according to GE installation requirements and verify network cable bend radius limitations during routing.

Before commissioning, confirm link status, network addressing parameters, protocol configuration, and communication integrity between the Mark VIe controller and connected industrial network devices.

Specifications

• Brand: General Electric

Advantages

• High reliability in industrial environments
• Supports continuous operation
• Compatible with major PLC/DCS systems