وصف

Bently Nevada 330980-51-00 Proximitor Sensor

Configured for proximity signal conversion in Bently Nevada 3300 XL NSv Proximitor Sensor systems, the Bently Nevada 330980-51-00 (330980 Proximitor Sensor) provides direct physical/electrical execution for eddy-current based displacement measurement within Bently Nevada transducer signal chains.

Suffix Breakdown & Model Matrix

• 51: 5.0 m (16.4 ft) system length, DIN rail mount configuration
• 00: No agency approval option required

Hardware Specifications

Parameter	Specification
Model	Bently Nevada 330980-51-00
Brand	Bently Nevada
Origin	USA
Weight	0.2 kg
Dimensions	8.13 cm x 6.12 cm x 6.35 cm
System Length	5.0 m (16.4 ft)
Output Resistance	50 ohm
Incremental Scale Factor	7.87 V/mm (200 mV/mil)
Sensor Material	A380 aluminum
Mounting Type	DIN rail / panel mount compatible

Bently Nevada Eddy-Current Transduction Characteristics

The 330980-51-00 operates as part of a 3300 XL NSv eddy-current measurement chain, implementing calibrated gap voltage conversion for radial vibration and shaft displacement tracking. The signal conditioning stage supports standardized scaling alignment at 7.87 V/mm, ensuring consistent translation from probe gap variation to voltage output within the proximitor interface loop.

Cross-talk suppression is implemented through optimized internal shielding and impedance matching (50 ohm output stage), reducing interference susceptibility in high-density machinery monitoring environments. The proximitor architecture supports stable gap voltage validation behavior in typical -10 VDC reference scaling systems used across Bently Nevada proximity probe assemblies.

Frequently Asked Questions

Q: Does the 330980-51-00 support hot-swap installation?
A: The module is not designed for energized hot-swap insertion. Signal loop disconnection is required prior to replacement to prevent transient excitation on the proximitor output stage.

Q: What is the impact of cable length on signal scaling accuracy?
A: The 5.0 m system length is factory matched. Deviations in extension length or connector impedance mismatch can affect eddy-current linearity and calibration accuracy.

Q: Can the 50 ohm output be interfaced directly to PLC analog inputs?
A: Direct connection is not recommended without proper signal conditioning or input impedance matching to maintain linear voltage transfer characteristics.

Field Installation Guidelines

• Maintain continuous shield grounding at a single earth reference point to prevent ground loop currents.
• Ensure DIN rail mounting stability with full mechanical seat engagement to avoid micro-displacement noise injection.
• Route sensor cabling separately from high-frequency drive or switching power lines to reduce electromagnetic coupling.
• Avoid sharp cable bends; maintain minimum bend radius consistent with industrial instrumentation wiring practices.
• Verify connector torque and contact integrity at both proximitor and probe termination points before system energization.

تحديد

• rtl">
  

المزايا

• موثوقية عالية في البيئات الصناعية
  
  

• يدعم التشغيل المستمر، متوافق مع أنظمة PLC/DCS الرئيسية