وصف

Bently Nevada 330101-00-16-10-02-00 3300 XL 8 mm Proximity Probe

Configured for eddy-current displacement measurement in Bently Nevada 3300 XL series machinery protection systems, the Bently Nevada 330101-00-16-10-02-00 (base model 330101) provides direct physical interface to rotating shaft proximity sensing circuits. It converts radial vibration or position into proportional voltage signals for real-time machinery condition monitoring.

Hardware Specifications

Parameter	Specification
Model	330101-00-16-10-02-00
Brand	Bently Nevada
Origin	USA
Weight	0.06 kg
Dimensions	112 x 1.5 x 1.2 cm
Operating Temp	-40 to 120 degC
Power Consumption	Supplied via system signal conditioning
Thread Type	3/8-24 UNF
Unthreaded Length	0.0 in
Overall Case Length	1.6 in
Total Length	1.0 m (3.3 ft)
Connector Type	Miniature coaxial ClickLoc connector, standard cable
Agency Approval	Not required

Eddy-Current Probe Scaling & Gap Voltage Validation

The probe operates with a linear range defined by target material conductivity and surface finish. For accurate scaling, perform gap voltage validation against a -10 VDC nominal bias point using a calibrated driver/demodulator. Rotor dynamics measurements require consistent probe mounting perpendicularity to avoid cross-talk suppression degradation between adjacent sensors. Calibration should be executed at the installed extension cable length to preserve system accuracy.

Frequently Asked Questions

Q: Can this probe be used with armored cable assemblies?

A: No. This configuration specifies an unarmored standard cable; substitution requires recertification of mechanical and electrical characteristics.

Q: What is the maximum permissible probe insertion depth?

A: Insertion must not exceed the case length minus thread engagement, ensuring no contact with rotating components under thermal expansion.

Q: Is hot-swapping supported on live machinery?

A: No. Always de-energize the associated signal conditioner before probe replacement to prevent transient overvoltage damage.

Field Installation Guidelines

Mount the probe using the supplied 3/8-24 UNF threads, torqued to manufacturer-recommended values. Maintain proper standoff from the shaft surface to achieve specified gap voltage. Ground the shield at the signal conditioner end only to prevent ground loops. Route cables away from high-current conductors and motor leads to minimize electromagnetic interference. Verify clearance during shaft rotation and thermal growth conditions prior to final tightening.

تحديد

• rtl">
  

المزايا

• موثوقية عالية في البيئات الصناعية
  
  

• يدعم التشغيل المستمر، متوافق مع أنظمة PLC/DCS الرئيسية