Keterangan

Honeywell CC-TAON11 Series C Analog Output IOTA

Configured for analog output signal termination in the Honeywell Experion PKS Series C system, the Honeywell CC-TAON11 (51306521-175) (CC-TAON11 Analog Output IOTA) provides direct electrical execution. It functions as the termination interface between Series C analog output modules and field devices, routing controller-generated 4-20 mA output signals to external loads while supporting redundant I/O configurations.

Suffix Breakdown & Model Matrix

The supplied documentation identifies a single catalog number only. No official suffix or option matrix is specified.

Parameter	Specification
Model	CC-TAON11 (51306521-175)
Brand	Honeywell
Origin	USA
Weight	Approx. 0.4 kg to 0.56 kg
Dimensions	Not specified
Operating Temp	-40 deg C to +70 deg C
Power Consumption	Not specified
Product Type	Analog Output Input Output Termination Assembly (IOTA)
System Compatibility	Experion PKS Series C
Module Type	Analog Output Termination Assembly
HART Support	Non-HART
Redundancy	Supports redundant configuration (12-inch version)
Number of Channels	16
Output Signal	4-20 mA current loop
Signal Resolution	12-bit or 16-bit processing (depends on paired I/O module)
Output Ripple	Less than 100 mV peak-to-peak across a 250 Ohm load at power line frequency
Output Readback Accuracy	+/- 4 % of full scale
Output Current Linearity	+/- 0.05 % of full scale nominal
Temperature Drift	0.005 % of full scale per deg C
Isolation	Galvanic isolation between channels and power supply
Storage Temperature	-40 deg C to +85 deg C
Relative Humidity	5 % to 95 % RH, non-condensing
Mounting	DIN rail

Channel-to-Channel Isolation

The CC-TAON11 provides galvanic isolation between field channels and the power supply to reduce the transfer of electrical disturbances into analog output circuits. The assembly is intended for standard 4-20 mA control loops and does not implement HART communication. Internal diagnostics support output signal verification, while open-wire detection identifies interrupted field wiring connected to actuators or other analog loads.

Frequently Asked Questions

Q: Does the CC-TAON11 support HART communication?
A: No. The documented version is a non-HART Analog Output IOTA intended for standard 4-20 mA analog output applications.

Q: Can the module be installed in a redundant I/O configuration?
A: Yes. The documentation specifies support for redundant configuration when used with the applicable 12-inch redundant arrangement.

Q: Does the termination assembly require firmware updates?
A: No firmware information is specified for the IOTA itself. Functional compatibility depends on the associated Series C analog output module and the Experion PKS hardware configuration.

Field Installation Guidelines

• Mount the IOTA securely on the designated DIN rail inside the Series C cabinet.
• Verify that the installed analog output module matches the specified CC-TAON11 termination assembly before field wiring.
• Route analog output wiring separately from high-voltage or high-current conductors to reduce electrical interference.
• Terminate cable shields according to the cabinet grounding practice defined for the control system, avoiding multiple shield ground points unless required by the installation standard.
• Confirm terminal identification before energizing field circuits and verify continuity if open-wire diagnostics indicate a disconnected load.
• Observe the specified environmental limits for operating temperature and humidity during installation and operation.

Spesifikasi

• Merek: Honeywell
• 
  :
  

Keuntungan

• Keandalan tinggi di lingkungan industri
  
  
• Mendukung operasi berkelanjutan
• Kompatibel dengan sistem PLC/DCS utama