GE IS215AEPAH1CA Mark VI Exciter Power Amplifier Board The GE IS215AEPAH1CA, also cataloged as the IS215AEPAH1CA Exciter Power Amplifier Board, operates as a...
Baca selengkapnya
Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
GE IS215AEPAH1CA Mark VI Exciter Power Amplifier Board
The GE IS215AEPAH1CA, also cataloged as the IS215AEPAH1CA Exciter Power Amplifier Board, operates as a dedicated hardware component for generator field excitation current control within GE Mark VI excitation control platforms. The board converts regulator commands into high-current DC field drive signals with electrical isolation between control and power circuits.
Hardware Specifications
Parameter
Specification
Model
IS215AEPAH1CA
Brand
GE
Origin
United States
Weight
0.5kg
Operating Temp
-30 to +65 deg C
Power Consumption
Not specified
Product Type
Exciter Power Amplifier Boards
Series
Mark VI Excitation System
Function
Excitation power amplification for synchronous generators
Input Control
Regulator signals from DSPX/EXTB boards
Output Current
Up to 50 A continuous excitation current
Field Voltage Range
0-300 VDC
Isolation
2500 Vrms between control and power circuits
Cooling Method
Forced-air cooling with integrated heat sink
Protection Functions
Overcurrent, overvoltage, thermal shutdown, field ground detection
Connectors
P1/P2 backplane connectors
Compliance
UL, CE, IEC 60034 excitation standards
Industrial Control and Excitation System Features
The IS215AEPAH1CA performs power amplification within the GE Mark VI excitation architecture. The board receives regulator control signals and provides amplified current output for synchronous generator field excitation circuits.
The module follows GE industrial control hardware design practices including deterministic backplane communication compatibility, I/O density scaling, and firmware flash compatibility within supported Mark VI system configurations. The P1/P2 backplane interface provides control and feedback signal exchange with connected excitation modules.
The excitation power stage incorporates protection functions for abnormal electrical conditions. The isolation structure separates low-level controller signals from high-current field circuits, while thermal management hardware supports continuous excitation operation under specified environmental conditions.
Frequently Asked Questions
Q: What is the primary function of the IS215AEPAH1CA board? A: The board amplifies regulator control signals and provides DC excitation current output for synchronous generator field control.
Q: What isolation capability is provided between control and power circuits? A: The board provides 2500 Vrms isolation between control-side and power-side circuits.
Q: Which interface connectors are used for system integration? A: The board uses P1/P2 backplane connectors for control and feedback signal connections within the Mark VI cabinet.
Field Installation Guidelines
Install the IS215AEPAH1CA in the designated Mark VI excitation cabinet position and verify mechanical alignment before inserting the board into the backplane interface.
Check P1/P2 connector seating and confirm that field output wiring matches the generator excitation system documentation. Route high-current excitation conductors separately from low-level control and feedback wiring.
Maintain proper grounding and shielding practices for control signal cables. Verify cooling airflow paths, heat sink clearance, and protection circuit status before energizing the excitation system.
