GE IS200WETBH1BAA Wet Bridge Terminal Board The GE IS200WETBH1BAA, also cataloged as the IS200WETB Wet Bridge Terminal Board, operates as a dedicated hardware...
Baca selengkapnya
Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
GE IS200WETBH1BAA Wet Bridge Terminal Board
The GE IS200WETBH1BAA, also cataloged as the IS200WETB Wet Bridge Terminal Board, operates as a dedicated hardware component for exciter bridge feedback acquisition and protective signal interfacing within the GE EX2100 Excitation Control System.
Hardware Specifications
Parameter
Specification
Model
IS200WETBH1BAA
Brand
General Electric (GE)
Origin
United States
Board Type
Wet Bridge Terminal Board (WETB)
Series
EX2100 Excitation Control System
Mounting
Rack-mounted exciter cabinet installation
Inputs
Generator field current feedback, exciter bridge voltage sensing
Outputs
Conditioned signals to EMIO and DSPX boards
Protection Features
Overcurrent detection and ground fault monitoring
Indicators
LED status indication for bridge signals
PCB Protection
Conformal coating for dust, moisture, and chemical resistance
Weight
1 lbs
Operating Temp
-30 to +65 deg C
Power Consumption
Not specified in available technical data
GE EX2100 Excitation Signal Interface Characteristics
The IS200WETBH1BAA provides the electrical interface between the exciter power bridge and EX2100 control electronics. The board processes generator field current feedback, bridge voltage sensing signals, and protective monitoring inputs before transmitting conditioned data to control modules.
The terminal board supports coordinated excitation control through integration with EMIO and DSPX boards. Its signal conditioning paths maintain separation between bridge-level electrical feedback circuits and low-level control electronics.
Backplane Bus Communication and Firmware Flash Compatibility
Within the EX2100 platform architecture, the IS200WETBH1BAA operates as a dedicated interface board for excitation feedback and protection signal handling. System communication depends on the connected EX2100 control modules and configured board firmware.
Module replacement requires verification of hardware revision, connector configuration, and compatibility with the installed EX2100 system configuration.
Frequently Asked Questions
Q: What signals are processed by the IS200WETBH1BAA board? A: The board processes exciter bridge voltage sensing, generator field current feedback, and protective monitoring signals for the EX2100 excitation control system.
Q: What type of protection functions are supported by this terminal board? A: The board supports monitoring functions including overcurrent detection and ground fault monitoring through connected excitation control circuits.
Q: Can the IS200WETBH1BAA operate as an independent excitation controller? A: No. The board functions as an interface terminal board and requires integration with EX2100 control modules such as EMIO and DSPX assemblies.
Field Installation Guidelines
Install the IS200WETBH1BAA in the designated EX2100 rack position according to the excitation system hardware layout. Verify connector alignment and terminal seating before applying system power.
Route bridge feedback wiring separately from high-current excitation conductors to reduce electrical interference. Maintain proper cable shielding and grounding practices for analog feedback circuits.
Handle the conformal-coated PCB using standard ESD protection procedures. Inspect connectors, terminal points, and board surfaces before installation to prevent contamination-related signal issues.
