Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
GE DS200PTCTG1BAA Mark V PT and CT Signal Conditioner Board
Configured for galvanic isolation and signal conditioning in GE Mark V Speedtronic turbine control platforms, the GE DS200PTCTG1BAA (DS200PTCT PT and CT Signal Conditioner Board) provides direct physical/electrical execution. It scales high-voltage potential transformer (PT) and current transformer (CT) input feedback down to low-voltage internal levels, suppressing noise and processing field signals into discrete digital representations required for real-time turbine protection, continuous monitoring, and governor loop calculations.
Hardware Specifications
Parameter
Specification
Model
DS200PTCTG1BAA
Brand
General Electric
Origin
United States
Weight
0.5 kg
Operating Temp
-30 deg C to +65 deg C
Power Consumption
+5 VDC @ 6 A
Auxiliary Supply Voltage
24 VDC
Input Voltage
120 VAC
System Frequency
60 Hz
Relay Channels
12
Mounting
DIN-rail
Technology
Surface mount
Backplane Bus Communication Velocity and Signal Processing
The DS200PTCTG1BAA module interfaces directly with the Mark V core system backplane, maintaining strict deterministic timing across high-density I/O configurations. Designed for demanding turbine power feedback environments, the board leverages precise hardware filtering circuits to minimize signal attenuation and latency during transient high-load events. The internal architecture optimizes backplane bus communication velocity and firmware flash compatibility, preventing data jitter and ensuring synchronized sample rates across all 12 relay channels during turbine trip and governor control operations.
Frequently Asked Questions
Q: What are the primary power rail requirements for the DS200PTCTG1BAA during operation?
A: The module requires a primary internal bus supply of +5 VDC at 6 A for digital logic and signal processing circuits, along with an auxiliary 24 VDC power input for onboard relay channel excitation.
Q: Can the board accept direct high-voltage potential transformer signals?
A: The board is designed to interface with standard instrument potential transformers rated up to 120 VAC at 60 Hz, providing galvanic isolation and onboard signal attenuation before conversion.
Q: Is hot-swapping permitted for this module during active turbine operation?
A: No. Standard Mark V maintenance protocols require shutting down power to the rack location before removing or inserting the board to prevent arc fault hazards on the 120 VAC PT and 24 VDC supply circuits.
Field Installation Guidelines
Verify that power to the panel card cage (+5 VDC and 24 VDC supplies) and field PT/CT primary lines (120 VAC) are completely de-energized prior to hardware handling or insertion.
Mount the assembly securely on standard DIN-rail infrastructure, ensuring proper mechanical engagement and ground continuity via the mounting hardware.
Ensure shield grounding wires for external PT and CT field wiring are terminated at designated single-point earth ground bars to eliminate high-frequency ground loops.
Maintain adequate physical spacing around the board perimeter to facilitate natural thermal heat dissipation across the surface-mount component matrix within the -30 deg C to +65 deg C operating envelope.
