Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
Bently Nevada 1701/15 Fieldbus Monitor Module
The Bently Nevada 1701/15, also cataloged as the 1701 Fieldbus Monitor Module, operates as a dedicated hardware component for interfacing machinery protection systems with Foundation Fieldbus and Profibus digital networks within industrial monitoring racks.
Hardware Specifications
Parameter
Specification
Model
1701/15 (Part No. 141379-01)
Brand
Bently Nevada
Origin
USA
Weight
0.2kg
Dimensions
Single-slot width for 1701 series rack
Operating Temp
-30 deg C to +65 deg C
Storage Temp
-40 deg C to +85 deg C
Humidity
95 % non-condensing max
Power Consumption
Low-power, supplied via rack backplane
Protocol Support
Foundation Fieldbus / Profibus PA/DP
Data Transfer Rate
Auto-baud or fixed per protocol specification
Hazardous Area Approvals
ATEX, IECEx, CSA for Zone 2 / Class I, Div 2
Eddy-Current Probe Scaling and Signal Integrity
The module maintains strict eddy-current probe scaling accuracy by aligning transducer output with calibrated gap voltage targets of -10 VDC. This ensures rotor dynamics measurements remain consistent under varying proximity probe conditions. Cross-talk suppression circuitry minimizes interference between adjacent channels, preserving fidelity in vibration and position datasets transmitted over the fieldbus.
Frequently Asked Questions
Q: Can the 1701/15 be hot-swapped without interrupting rack operation?
A: Hot-swapping is not recommended unless the rack firmware explicitly supports it; always verify compatibility before removal.
Q: Does the module require separate power wiring for the fieldbus side?
A: No. Power is derived from the rack backplane, with galvanic isolation preventing ground loops between fieldbus and internal logic circuits.
Field Installation Guidelines
Install the module in a properly grounded 1701 series rack enclosure. Ensure shield terminations are connected to the rack’s designated earth bar to maintain signal integrity. Maintain separation between fieldbus cabling and high-voltage power wiring to reduce electromagnetic interference. Verify firmware revision compatibility prior to installation to prevent communication faults.
