GE DS200SVAAG1A Voltage Attenuator Board The GE DS200SVAAG1A, also cataloged as the DS200SVAA Voltage Attenuator Board, operates as a dedicated signal conditioning hardware...
Baca selengkapnya
Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
GE DS200SVAAG1A Voltage Attenuator Board
The GE DS200SVAAG1A, also cataloged as the DS200SVAA Voltage Attenuator Board, operates as a dedicated signal conditioning hardware component for analog voltage attenuation within GE Mark V Speedtronic turbine control system platforms. It provides isolated scaling of field voltage inputs into controller-compatible analog levels through passive attenuation circuits and electrical isolation paths.
Hardware Specifications
Parameter
Specification
Model
DS200SVAAG1A
Brand
GE
Origin
United States
Weight
0.5 kg
Operating Temp
-30 to +65 deg C
Power Consumption
Passive board design; powered by 28 VDC system supply
Product Type
Voltage Attenuator Board
Series
Drive Control
System Compatibility
GE Mark V Speedtronic turbine control system
Input Voltage Range
Up to +/-200 VAC/VDC depending on configuration
Output Voltage Range
+/-10 VDC conditioned signal
Channels
Multiple isolated analog input channels
Accuracy
+/-0.1% FS
Isolation Rating
2500 Vrms channel-to-ground
Response Time
<5 ms
Mounting Type
Rack-mount, single-slot
Technology
Surface mount electronics
GE Mark V Analog Signal Attenuation and Isolation
The DS200SVAAG1A performs analog voltage scaling between field-level signals and GE Mark V controller input circuits. The board attenuates higher amplitude voltage signals into a +/-10 VDC output range suitable for turbine control processing. Channel isolation supports separation between input circuits and control electronics, reducing ground loop effects and electrical interference.
The board architecture follows GE industrial control hardware practices, using surface mount components and rack-based installation within Speedtronic control cabinets. Signal conditioning functions include voltage reduction, analog stabilization, and electrical interface adaptation.
Firmware and I/O Interface Characteristics
The DS200SVAAG1A operates as a hardware-level interface board without independent firmware execution. Diagnostic information is handled through connected GE Mark V processor and controller boards. The analog interface design supports deterministic signal transfer within turbine control I/O architectures.
Frequently Asked Questions
Q: Does the DS200SVAAG1A execute application firmware independently? A: No. The board is a passive voltage attenuation and signal conditioning module. Monitoring and control functions are performed by connected GE Mark V processor boards.
Q: What signal conversion function does the DS200SVAAG1A provide? A: The board attenuates incoming high-level analog voltage signals and provides conditioned +/-10 VDC outputs for controller processing.
Q: What installation factors affect analog signal performance? A: Shielding, grounding practices, cable routing, and separation from high-current conductors affect analog signal integrity.
Field Installation Guidelines
Install the DS200SVAAG1A in the designated GE Mark V rack slot with the correct backplane connection. Verify board alignment before insertion to prevent connector damage.
Use shielded instrumentation wiring for analog signal connections where required. Terminate cable shields according to cabinet grounding practices and avoid routing analog signal cables parallel to high-voltage or high-current wiring.
Confirm that field voltage inputs remain within the specified board configuration range before energizing the system. Inspect connectors, terminal points, and rack seating during commissioning procedures.
