ABB DSQC658 DeviceNet M/S Single The ABB DSQC658 3HAC025779-001, also cataloged as the DSQC658 DeviceNet communication board, provides DeviceNet master/slave...
Baca selengkapnya
Dukungan Pengembalian Dana, Layanan 7X24jam, Hubungi kami .
Hubungi kami: +86 135 995 07613
Tersedia pada hari kerja antara pukul 09.00 hingga 18.00
Email kami: sales2@industriaxplc.com
Tersedia 24/7 untuk pertanyaan dan dukungan
Keterangan
ABB DSQC658 DeviceNet M/S Single
The ABB DSQC658 3HAC025779-001, also cataloged as the DSQC658 DeviceNet communication board, provides DeviceNet master/slave communication within ABB IRC5 controllers. It exchanges control and status data with connected DeviceNet nodes through the controller network interface.
Hardware Specifications
Parameter
Specification
Model
DSQC658
Brand
ABB
Part Number
3HAC025779-001
Product Type
DeviceNet Communication Board, Master/Slave Single
Compatible Controller
ABB IRC5 Robot Controller
Communication Protocol
DeviceNet, CAN-based fieldbus
Supported Baud Rates
125 kbps, 250 kbps, 500 kbps
Operating Voltage
24 VDC
Weight
Approx. 0.08 kg
Dimensions
Estimated shipping size: 2 x 8.7 x 12.5 cm
Operating Temp
0 deg C to +55 deg C
Power Consumption
Not specified in supplied data
Mounting
Internal board installation in IRC5 controller
Protection Rating
IP20
Diagnostic Indicators
Power, module status, network status LEDs
Network Function
DeviceNet Master/Slave, single interface
ABB Industrial Network and Backplane Integration
The DSQC658 provides a DeviceNet interface for exchanging cyclic and diagnostic data between the IRC5 controller and external nodes. Therefore, the board supports bus-based I/O communication instead of point-to-point discrete wiring.
DeviceNet uses CAN-based communication, while the available baud rates provide selectable network operating speeds. The installation must match the configured network baud rate and node settings.
In addition, the board uses status indicators to assist with power, module, and network diagnostics. Technicians can therefore identify basic communication conditions directly at the controller hardware.
The supplied data identifies the DSQC658 as a single Master/Slave DeviceNet interface. It does not specify redundant DeviceNet operation, hot-swap capability, or a defined backplane current load.
Frequently Asked Questions
Q: Can the DSQC658 operate as both a DeviceNet Master and Slave? A: Yes. The supplied product designation identifies the unit as a DeviceNet Master/Slave Single interface.
Q: What DeviceNet communication speeds does the DSQC658 support? A: The supplied specifications list 125 kbps, 250 kbps, and 500 kbps.
Q: Does the supplied data confirm hot-swap operation? A: No. The supplied documentation does not specify hot-swap support. Treat the board as an internal controller component and follow the applicable IRC5 service procedure before removal or installation.
Field Installation Guidelines
Isolate controller power before installing or removing the internal communication board.
Verify the DSQC658 part number, board identification, and controller compatibility before installation.
Route DeviceNet cabling separately from high-current motor and power wiring where practical.
Maintain the DeviceNet cable shield and termination arrangement specified by the network design.
Verify node addressing, baud rate, and network configuration before placing the controller into normal operation.
Inspect connectors for correct seating and mechanical retention before energizing the controller.
Use the front-panel diagnostic LEDs to check module and network status after startup.
Do not assume hot-swap capability unless the applicable ABB IRC5 hardware documentation explicitly permits it.
