Keterangan
Bently Nevada 3500/25-01-05-05 Enhanced Power Supply Module
Configured for regulated DC distribution in 3500 rack backplane power architecture, the Bently Nevada 3500/25-01-05-05 (3500/25 Power Supply Module) provides direct electrical execution for all installed monitoring and interface modules within the 3500 Machinery Protection System.
The module converts AC or DC input into regulated backplane DC power and supports dual-module redundancy with automatic switchover. Power integrity of the rack directly affects signal conditioning stability across vibration and Keyphasor measurement chains, including eddy-current probe scaling reference consistency and gap voltage validation stability under dynamic load conditions.
Hardware Specifications
| Parameter |
Specification |
| Model |
3500/25-01-05-05 |
| Brand |
Bently Nevada |
| Weight |
0.45 kg |
| Operating Temp |
-20 deg C to +65 deg C |
| Form Factor |
Half-height module |
| Rack Compatibility |
3500 full-size and mini-rack |
| Input Types |
Universal AC / High Voltage DC / Low Voltage DC |
| Universal AC Input |
85–264 Vac rms, 47–63 Hz |
| High Voltage DC Input |
88–140 Vdc |
| Low Voltage DC Input |
20–30 Vdc |
| Redundancy |
Dual supply with automatic switchover |
| Protection |
Under-voltage safe; over-voltage fuse action on PIM |
Bently Nevada Rack Power Integrity and Signal Stability Behavior
The 3500/25 power module maintains regulated DC rail stability across the 3500 backplane, ensuring consistent excitation conditions for transducer signal conditioning chains. Variations in supply stability can influence eddy-current probe scaling reference drift and affect gap voltage validation thresholds used in rotor dynamics measurement chains.
Backplane voltage stability is also linked to cross-channel synchronization of vibration modules, where unstable supply conditions may introduce measurement offset in high-resolution signal conditioning paths used for proximity and seismic transducers.
Frequently Asked Questions (FAQ)
Q: Can the module be hot-swapped without affecting rack signal acquisition?
A: Yes. The module supports hot-swapping with redundant configuration. In single-supply operation, removal will interrupt backplane DC distribution.
Q: What happens to monitoring modules during redundant switchover?
A: In dual-module configuration, automatic switchover maintains backplane voltage continuity. Transient dip is controlled within rack power architecture limits.
Q: Does the module affect transducer signal conditioning accuracy?
A: Indirectly. It does not process signals, but unstable backplane power may influence signal conditioning reference stability across connected modules.
Field Installation Guidelines
-
Install module only in designated left-side rack power slot.
-
Ensure rack power is isolated before single-module insertion or removal unless redundancy is active.
-
Verify backplane connector alignment before full insertion to avoid pin damage.
-
Maintain shielded grounding integrity of rack chassis to stabilize reference potential.
-
Do not route external signal cabling near power input harness to minimize electromagnetic coupling.
