Keterangan

Bently Nevada 284398-01 991 Thrust Transmitter

Configured for axial displacement signal conversion in Bently Nevada machinery monitoring systems, the Bently Nevada 284398-01 (284398-01 991 Thrust Transmitter) provides direct physical/electrical execution between 3300 NSv proximity probe inputs and 4-20 mA output loops.

Hardware Specifications

Parameter	Specification
Model	284398-01
Brand	Bently Nevada
Product Type	991 Thrust Transmitter
Series	991 Series
Origin	USA
Weight	0.22 kg
Dimensions	88 mm x 35 mm x 70 mm
Operating Temp	-40 deg C to +85 deg C
Power Consumption	Loop powered, 18 to 30 VDC supply
Input Signal	3300 NSv eddy-current proximity probe signal
Output Signal	4-20 mA proportional axial displacement output
Measurement Range	Approximately +/- 1.0 mm
Accuracy	+/- 0.5% full scale
Probe System Compatibility	5 m or 7 m probe extension system
Signal Interface	Two-wire loop powered transmitter
Housing Protection	IP65
Mounting Type	Industrial field mounting

Eddy-Current Probe Scaling and Rotor Position Measurement

The 284398-01 transmitter processes eddy-current probe displacement signals and converts probe gap variations into a proportional 4-20 mA axial position signal. The input circuit maintains scaling between the 3300 NSv proximity probe system and the connected monitoring or control equipment.

The transmitter operation depends on correct probe calibration and gap voltage validation. Bently Nevada proximity measurement systems typically use -10 VDC target gap voltage references for probe operating point verification. Proper gap setting allows accurate rotor thrust position measurement and reduces measurement deviation caused by incorrect probe installation.

The unit supports machinery condition monitoring applications where rotor dynamics and axial movement data are required. The signal conversion path provides compatibility with PLC, DCS, and machinery protection interfaces using standard analog current loops.

Frequently Asked Questions

Q: What type of sensor input does the 284398-01 accept?
A: The transmitter accepts input signals from Bently Nevada 3300 NSv eddy-current proximity probe systems for axial displacement measurement.

Q: What electrical output is provided by the transmitter?
A: The unit provides a two-wire loop powered 4-20 mA output proportional to measured thrust position.

Q: What installation factor affects measurement accuracy?
A: Correct probe gap adjustment, cable configuration, and signal wiring practices affect axial position measurement performance.

Field Installation Guidelines

• Install the transmitter according to the specified environmental limits and mechanical mounting requirements.
• Verify the proximity probe gap voltage before commissioning the measurement loop.
• Use shielded signal wiring and maintain proper cable separation from high-voltage power conductors.
• Confirm compatibility between the 3300 NSv probe, extension cable length, and transmitter configuration.
• Connect the 4-20 mA loop with correct polarity and verify the receiving PLC or DCS analog input scaling.

Spesifikasi

• Merek: Bently Nevada
• 
  :
  

Keuntungan

• Keandalan tinggi di lingkungan industri
  
  
• Mendukung operasi berkelanjutan
• Kompatibel dengan sistem PLC/DCS utama